HP OneView - Manual (Page 53)

information on obtaining a certificate with a browser, see “Managing certificates from a browser”
(page 50)
3.12 Ports needed for HP OneView
HP OneView requires specific ports to be made available to the appliance to manage servers,
enclosures, and interconnects.
Table 1 Required ports
Description Usage Protocol Port number
Used for HTTP interface. Typically, this port redirects to port
443; this port provides the access that iLO requires. Inbound TCP 80
HP OneView acts as an NTP server, both iLO and Onboard
Administrator require access. Inbound UDP 123
The appliance uses this port as an NTP client to synchronize
the appliance time. Outbound UDP 123
Supports SNMP GET calls to obtain status data from a server
through iLO. Also used for iPDU. Outbound UDP 161
Used for SNMP trap support from the iLO, Onboard
Administrator, and iPDU devices. Inbound UDP 162
Used for the HTTPS interface to user interface and APIs. Inbound TCP 443
Used for secure SSL access to the iLO and Onboard
Administrator. Used for RIBCL, SOAP, and iPDU
communication. Outbound TCP 443
Used as an alternative SNMP trap port. Inbound UDP 2162
Used to allow external scripts or applications to connect to
and monitor messages from the SCMB (State Change Message
Bus). Inbound TCP 5671
Provides browser access to the remote console. Browser to iLO TCP 17988
Provides remote console access to iLO virtual media. Browser to iLO TCP 17990
3.13 Access to the appliance console
Restrict access to the appliance console (by using the hypervisor management software) to prevent
unauthorized users from attempting to access the password reset and service access features. See
“Restricting console access” (page 54) .
Typical legitimate uses for access to the console are:
•
Troubleshooting network configuration issues
•
Resetting an appliance administrator password.
•
Enabling service access by an on-site authorized support representative.
The virtual appliance console is displayed in a graphical console; password reset and HP Services
access use a non-graphical console.
Switching from one console to another
1. Open the virtual appliance console from vSphere.
2. Press and hold Ctrl+Alt.
3. Press and release the space bar.
4. Press and release F1 to select the non-graphical console or F2 to select the graphical console.
3.12 Ports needed for HP OneView 53