HP OneView - Manual (Page 95)

10 Quick Start: Adding a network to an existing appliance
environment
This quick start describes the process to add a network to an existing appliance environment and
enable existing server blades to access the network you added.
NOTE: If you are performing initial configuration steps after installing an appliance, HP
recommends that you add networks and network sets before you add enclosures. See “Quick Start:
Initial Configuration” (page 91) .
Prerequisites
•
Minimum required privileges: Infrastructure administrator or Network administrator for adding
the network.
•
Minimum required privileges: Infrastructure administrator or Server administrator for changing
the configurations of the server profiles.
•
The enclosures and server blades are already added to the appliance.
•
All data center switch ports that connect to the VC (Virtual Connect) interconnect modules are
configured as described in
“Data center switch port requirements” (page 115) .
95