A.3 planning the configuration, A.3.1 planning for installation of the appliance – HP OneView User Manual
Page 236
Table 15 Development networks
VLAN ID
Name
1105
dev 1105
1106
dev 1106
1107
dev 1107
1108
dev 1108
Table 16 Test networks
VLAN ID
Name
1111
test 1111
1112
test 1112
1113
test 1113
1114
test 1114
Table 17 Ethernet network configuration values
Notes
Value
Configuration attribute
Ethernet
Type
This is the default value displayed on the Create network screen.
2.5 Gb/s
Preferred bandwidth
This is the default value displayed on the Create network screen.
10 Gb/s
Maximum bandwidth
This is the default value displayed on the Create network screen.
Selected
Smart link
This is the default value displayed on the Create network screen.
Not selected
Private network
A.3 Planning the configuration
A.3.1 Planning for installation of the appliance
For the sample data center, assume that you make the following choices before and during
installation:
•
You follow the recommendations in the HP OneView Installation Guide, including:
Choosing a physical host for the appliance virtual machine (VM) that is not targeted to
be managed by this appliance
◦
◦
Choosing a static IP address
◦
Ensuring that the ports required by the appliance are available
•
You allow support personnel to access the appliance.
•
You synchronize the appliance time with the VM host time.
•
When prompted to change the Administrator password, you use the password SDC14u$.
•
You specify the following for the appliance networking settings:
Value
Configuration attribute
myhostname.example.com
Appliance host name
Manual
IPv4 address assignment
255.255.240.0
Subnet mask
236 Step by step: Configuring an example data center using HP OneView