HP OneView - Manual (Page 241)

k. Click Create + to create another network.
The appliance creates the network and opens the Create network dialog box. This dialog
box uses the configuration values you selected in the preceding steps, except for the name
and VLAN ID.
3. Create the production networks.
For this procedure, you use the default values displayed on the Create network dialog box.
Because all of the configuration values for production networks are the same except for the
name and VLAN ID, you follow the same procedure for each network.
a.
For Name, enter the name of the network.
b. For VLAN ID, enter the VLAN ID of the network.
c. For Purpose, select General.
d. Click Create + to create another network.
Use the following names and VLAN IDs for the production networks:
VLAN ID Name
1101 prod 1101
1102 prod 1102
1103 prod 1103
1104 prod 1104
Behind the Create network screen, you also might see the networks you create listed in the
master pane of the Networks screen as those networks are added.
4. Create the development networks and test networks.
For this procedure, you continue to use the default values displayed on the Create network
dialog box. Because all of the configuration values for production networks are the same
except for the name and VLAN ID, you follow the same procedure for each network:
a.
For Name, enter the name of the network.
b. For VLAN ID, enter the VLAN ID of the network.
c. Click Create + to create another network.
When you finish entering the values for the last Ethernet network you want to create, click
Create instead of Create +. The Networks screen opens.
Use the following names and VLAN IDs for the development networks:
VLAN ID Name
1105 dev 1105
1106 dev 1106
1107 dev 1107
1108 dev 1108
Use the following names and VLAN IDs for the test networks:
VLAN ID Name
1111 test 1111
1112 test 1112
1113 test 1113
1114 test 1114
A.5 Provisioning eight host servers for VMware vSphere Auto Deploy 241