Shutting down the system, Shutting the controller down using the lcd menu, Shutdown methods – HP 3000 Enterprise Virtual Array User Manual
Page 99
17.
Press
to display the Battery PIC.
18.
Press
to display the Versions Menu tree.
19.
Press
to scroll to the PowerPC Processor.
20.
Press
to display the PowerPC Processor.
21.
Press
to display the Versions Menu tree.
22.
Press
to scroll to the Quasar version.
23.
Press
to display the Quasar version.
24.
Press
to display the Versions Menu tree.
Shutting down the system
CAUTION:
To power off the system for more than 96 hours, use Command View EVA.
You can use the shutdown system function to implement the following shutdown methods: (see
)
•
Restarting the system (see
•
Turning off the power (see
).
•
Uninitializing the system (see
).
To ensure that you do not mistakenly activate a shutdown procedure, the default state is always NO,
indicating do not implement this procedure. Implementing any shutdown method requires you to
complete at least two actions.
Table 29 Shutdown methods
LCD prompt
Description
RESTART
Implementing this procedure establishes communications between the storage
system and Command View EVA. This procedure is used to restore the
controller to an operational state where it can communicate with Command
View EVA
POWER OFF
Implementing this procedure initiates the sequential removal of controller
power. This ensures no data is lost. The reasons for implementing this
procedure include replacing a disk drive enclosure.
SYSTEM UNINITIALIZE
Implementing this procedure will cause the loss of all data. For a detailed
discussion of this procedure, see
Shutting the controller down using the LCD menu
Use the following procedure to select the Shutdown System display and execute a shutdown procedure.
NOTE:
Command View EVA is the preferred method for shutting down the controller. Shut down the controller
from the OCP only if Command View EVA cannot communicate with the controller.
Shutting down the controller from the OCP removes power from the controller on which the procedure is
performed only. To restore power, toggle the controller’s power switch.
Enterprise Virtual Array 3000/5000 user guide (VCS 3.110)
99