HP 3PAR Operating System Software - Manual (Page 48)

The RCFC tab is divided into a list pane and a detail pane. The list pane displays a summary of
all RCFC ports in the system. The detail pane displays detailed information about a single port
selected from the list pane.
List Pane
The list pane displays the following information:
Description Column
The port location in Node:Slot:Port format. Position
The state of the port. See “System and Component Status Icons” (page 508) . State
Port firmware mode setting. Ports in Initiator mode are connected to drive cages and
ports in Target mode export to hosts. Suspended mode is for target ports that have not
yet been initialized by the system (rare). Peer mode is for Ethernet ports. Mode
Type of connection (Private Loop, Public Loop, or Point-Point). Topology
Rate that data can be transferred over the port (1 Gbps, 2 Gbps or 4 Gbps). When
there is no specified value, no connection exists. Rate
World Wide Name of the remote port. Remote Port WWN
World Wide Name of the remote node. Remote Node WWN
Detail Pane
The detail pane provides detail information about a selected RCFC port from the list pane.
Information is presented on a Summary tab, and depending on your system setup, an SFP tab.
Each are discussed in detail in the following sections:
“RCFC Port Summary Tab” (page 48)
“SFP Tab” (page 50)
RCFC Port Summary Tab
The RCFC port summary is displayed on the Summary tab.
48 Managing Ports