HP 3PAR Operating System Software - Manual (Page 249)

Creating a Peer Motion Configuration
To use the Create PM Configuration wizard, the following conditions are required:
•
Storage systems must meet all the requirements
. See the HP 3PAR Peer Motion Guide.
•
Super user role.
•
At least one available source system and destination system that are not in a Peer Motion
configuration.
Perform the following tasks before using the wizard:
•
Choose two host ports on the source system. (You will need this information to zone the source
and destination systems.)
•
Configure the two host ports if not already configured.
The Create PM Configuration wizard shows you how to configure two peer ports on the destination
system and zoning two systems into a Peer Motion configuration.
To create a Peer Motion Configuration:
1. Select Peer Motion in the Manager Pane.
2. Select Available Storage Systems in the Management Tree.
3. In the Common Actions panel, click Create PM Configuration to open the Create PM
Configuration wizard.
Select Systems
1. Click the icon and select a source system.
2. Click the icon and select a destination system.
Creating a Peer Motion Configuration 249