HP 3PAR Operating System Software - Manual (Page 288)

Description Field Group
For RCIP ports, the MAC address of the Ethernet interface. MAC IP Settings
(displayed for
For iSCSI ports, indicates whether the DHCP protocol is enabled. DHCP RCIP and
iSCSI ports -
not shown)
IP address of the iSCSI or RCIP port. IP Address
The address of a local IP router on the same network as the system, used to forward
traffic to destinations beyond the local network. Gateway
The netmask address for the iSCSI or RCIP interface. Subnet Mask
The greatest amount of data or "packet" size that can be transferred at one time
over a particular network connection without overburdening the connection. The MTU
default MTU setting for an iSCSI port is 1500. When supported by the network,
an MTU value of 9000 should be used.
For RCIP ports. The configured data transfer rate. A value of 0 indicates that no
data is being transferred. Configured Rate
For iSCSI ports. Data transfer rate. A value of 0 indicates that no data is being
transferred. Rate
The TCP port number used by the iSCSI card. TCP Port
For RCIP ports. The duplex speed: Half or Full. Duplex
For RCIP ports, the model of the adapter that contains the port (for example, Intel
PRO/1000MT). Adapter Type
The type of connection (for example, Fabric Attached). Topology Fibre Channel
Settings
Identifies which Fibre Channel classes of service are enabled (2, 3, or 2/3). A
value of 2/3 indicates that both Class 2 and Class 3 are enabled. Class
(displayed for
FC and RCFC
ports)
Model of the Fibre Channel adapter that contains the port (such as QLOGIC
2302). Adaptor Type
Indicates whether port mode change from initiator to target or vice versa is Allowed
or Prohibited. This setting is configured using the CLI controlport command. Mode Change
Primary Internet Storage Name Service (iSNS) server IP address. iSNS protocol
allows for automated discovery, management, and configuration of iSCSI. Primary IP Address iSNS Settings
(displayed for
iSCSI ports -
not shown)
The port on the iSNS server with which to communicate. TCP Port
Viewing Available Storage Systems
The Available Storage tree node list the names of all available storage systems that can be used
for data migration and provides summary information in the Management Window.
The following information displays for each available system. Click a system name to display
available storage system summary information and alerts that are associated with the system. For
288 Using Peer Motion in HP 3PAR Management Console Manager