Controlport, Name, Syntax – HP 3PAR Operating System Software User Manual
Page 232: Authority, Subcommands
controlport
NAME
controlport
-- The controlport command controls all aspects of a Fibre Channel or Remote
Copy port, including the port’s connection type and data rate. The controlport rcip and
controlport rcfc
commands are required for setting up Remote Copy interfaces.
SYNTAX
The syntax for the controlport rcip and rcfc commands can be one of the following:
•
controlport config
enable|disable] [-f]
•
controlport rst [-m
•
controlport offline
•
controlport lip [-c
•
controlport ct
•
controlport cl2
•
controlport rate
•
controlport vcn
•
controlport nssync [-f]
•
controlport intcoal
•
controlport rcip addr [-f]
•
controlport rcip gw [-f]
•
controlport rcip delete [-f]
•
controlport rcip mtu
•
controlport rcip state up|down [-f]
•
controlport rcip speed
•
controlport rcip speed auto
•
controlport rcip ping [-c
•
controlport rcfc init [-f]
•
controlport rcfc delete [-f]
AUTHORITY
Super, Service
Any role granted the port_control right.
NOTE:
You need access to all domains in order to run this command.
SUBCOMMANDS
config
Sets the specified connection mode and type on FC ports. Also allows setting the unique node
WWN option for the port. When unique_nwwn is enabled, the port presents a unique node
name on the connection and this is needed by certain initiators such as ONTAP.
rst
Resets a port.
232 The Remote Copy Commands