HP 3PAR Operating System Software User Manual
Page 231
.
.
.
============================================================
TEST SUMMARY from 0:0:1 -> 10.100.18.164
Test Started: Wed Aug 10 10:34:15 PST 2011
Test Finished: Wed Aug 10 10:34:26 PST 2011
============================================================
Latency: 0.104 ms
Lost pings: 0 %
Through-put: 522 Mbits/second
Max MTU: 1500
Tx TCP Segs: 486675
Rx TCP Segs: 199271
TCP retrans: 0 %
Errored Segs: 0 %
Link 2:5:1 is SUITABLE for Remote Copy Use
SystemB# checkrclink stopserver
NOTES
•
Do not check the links if CPU usage is already close to 100%. The link check temporarily
increases CPU usage.
•
This test must be performed in two stages. To run a test between SystemA and SystemB:
Start the system on SystemB, specifying the
for SystemA.
a.
# checkrclink startserver
If you are running the checkrclink test on RCFC links, note the IP address displayed in the
output.
b.
Start the client on the target system (SystemA), specifying the
for SystemB (as an IP address for both RCIP and RCFC links); and the
duration of the test in seconds.
# checkrclink startclient
c.
(Optional) To end the test before it completes, on SystemA enter:
# checkrclink stopclient
d.
After the test is complete, on SystemB enter:
# checkrclink stopserver
231