HP 3PAR Operating System Software - Manual (Page 281)

–sortcol [,
Sorts command output based on column number (). Columns are numbered from left
to right, beginning with 0. You must specify a column number.
In addition, you can specify the direction of sorting (
inc - Sort in increasing order (the default).
•
dec - Sort in decreasing order.
-filt
Specifies that statistics that fall below the threshold specified by the argument are
filtered out and not displayed. To specify the argument, use the syntax:
,,,
. The arguments are separated by one comma.
•
type - The type argument can be specified with one of the following arguments:
curs - Specifies that only devices with current statistics above the threshold are
displayed.
◦
◦ avgs - Specifies that only devices with average statistics above the threshold are
displayed.
◦ maxs - Specifies that only devices with maximum values above the threshold are
displayed.
•
op - The operation argument can be specified with one of the following arguments:
r - Specifies that read-only statistics are displayed. ◦
◦ w - Specifies that write-only statistics are displayed.
◦ t|rw - Specifies that statistics for read and write totals are displayed.
•
meas - The measure argument can be specified with one of the following arguments:
iops - Specifies that I/O operations per second are displayed. If this argument is
used, the minimum threshold value must be specified using the argument.
◦
◦ bw - Specifies that statistics for bandwidth in bytes per second are displayed. If this
argument is used, the minimum threshold value must be specified using the
argument.
◦ svct - Specifies that statistics for service time in milliseconds are displayed.
◦ size - Specifies that statistics for I/O operations in bytes are displayed.
•
[k|K]|[m|M]|[g|G] - Specifies the minimum threshold using any integer. The
integer can be optionally followed with k or K to indicate a multiple of 1000, m or M to
indicate a multiple of 1000000, or g or G to indicate a multiple of 1000000000.
For example, –filt curs,r,iops,10k specifies that statistics for a device that has more
than 10,000 current read-only I/O operations are displayed.
-ni
Displays statistics for non-idle devices. This option is shorthand for the option -filt
curs,t,iops,0
.
SPECIFIERS
...
Displays statistics only for the specified virtual volume or volume name pattern. Multiple volumes
or patterns can be repeated (for example, ...). If not specified, all
virtual volumes that are configured for Remote Copy are listed.
RESTRICTIONS
None.
281