HP 3PAR Operating System Software - Manual (Page 110)

Link Information
Target Node Address Status Options
System2 0 10.100.33.11 Up
System2 1 10.101.33.11 Up
receive 0 10.100.33.11 Up
receive 1 10.101.33.11 Up
Group Information
Name Target Status Role Mode Options
sync_group_1 System2 Started Secondary-Rev Sync
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
localvv.0 413 remotevv.0 375 Syncing Thu Dec 14 17:58:25 PST 2006
localvv.1 414 remotevv.1 376 Syncing Thu Dec 14 17:58:25 PST 2006
Name Target Status Role Mode Options
sync_group_2.r11 System2 Stopped Secondary Sync
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
remotevv.0 423 localvv.0 385 Stopped Thu Dec 14 17:51:49 PST 2006
remotevv.1 424 localvv.1 386 Stopped Thu Dec 14 17:51:44 PST 2006
4. Verify that the volume groups are started. On the recovered system (System1), enter:
# showrcopy groups
•
- Volume group that should be started (sync_group_1)
Solution Problem
If the volume groups are not
started: 1. On the recovered system, issue:
startrcopygroup
or:
startrcopygroup -pat
(For example: startrcopygroup -pat sync*)
2. Wait for the synchronizations to complete before continuing.
CAUTION: The volume groups must be started before you continue to the next step and issue
the setrcopygroup restore command.
5. Restore the natural direction of data flow to the Remote Copy pair. On the failover system
(System2), enter:
# setrcopygroup restore -t
•
- Name of the target (recovered) system (System1)
110 Disaster Recovery for 1-to-1 Configurations