HP 3PAR Operating System Software - Manual (Page 94)

Stopping and Starting Remote Copy
To stop Remote Copy temporarily:
# stoprcopy -stopgroups
To restart Remote Copy:
# startrcopy
Removing Remote Copy Completely
WARNING! Removing the Remote Copy setup erases all Remote Copy configuration and is not
reversible.
If you decide to use Remote Copy after removing it completely, you must set up and configure
Remote Copy from the beginning.
To completely remove the Remote Copy setup:
# stoprcopy -stopgroups -clear
The stoprcopy -stopgroups -clear command:
•
Stops Remote Copy on all volume groups
•
Deletes all Remote Copy configuration data
•
Releases all resources used by Remote Copy
•
Is not reversible
NOTE: For important information about space allocation and deleted snapshots, see “Virtual
Volumes and CPGs” (page 187) .
94 Performing Manual Operations