HP 3PAR Operating System Software - Manual (Page 29)

5 Gathering Setup Information
1. Contact your network administrator to obtain:
• IP addresses or 64-bit World Wide Name (WWN) address information for the interfaces of the storage systems
• Gateway IP addresses, netmask, and IP addresses for each link
• Any additional details about the network connections that might be useful
2. Verify that the firewall settings allow the Remote Copy systems access to port 5785.
3. Use the provided worksheets to organize the data. Use multiple copies of the relevant worksheet if the Remote Copy
configuration has more than two systems.
Use these worksheets: To organize data for this configuration:
Figure 13 (page 30) Unidirectional 1-to-1 RCIP
Bidirectional 1-to-1
Figure 13 (page 30) N-to-1
and 1-to-N
Figure 14 (page 31) as many times as necessary Synchronous Long Distance
Figure 15 (page 32) Unidirectional 1-to-1 RCFC
Bidirectional 1-to-1
Figure 15 (page 32) as many times as necessary N-to-1
1-to-N
Synchronous Long Distance
RCIP Initial Remote Copy Pair
Figure 12 (page 29) illustrates the initial Remote Copy pair in an RCIP configuration.
Figure 12 Network and Remote Copy Over IP Setup Information (Initial Pair)
RCIP Initial Remote Copy Pair 29