HP 3PAR Operating System Software - Manual (Page 218)

Quick Setup: Synchronous Long Distance Remote Copy
Table 6 Quick Setup Steps for Synchronous Long Distance Configurations
Periodic System Sync System Primary System Reference Step
— — startrcopy “Setting Up the
Primary System”
(page 59) 1. Start Remote Copy.
— — Assuming RCFC:
creatercopytarget “ 2. Define target for
sync backup
system.
FC
:
— — Assuming RCIP:
creatercopytarget “ 3. Define target for
periodic backup
system.
IP
:
— startrcopy — “Setting Up the
Backup Systems”
(page 59) 4. Start Remote Copy.
— Assuming RCFC:
creatercopytarget — “ 5. Define target for
primary system.
FC
:
— Assuming RCIP:
creatercopytarget — “ 6. Define target for
periodic backup
system.
IP
:
startrcopy — — “ 7. Start Remote Copy.
creatercopytarget
IP
:
— — “ 8. Define target for
primary system.
creatercopytarget
IP
:
— — “ 9. Define target for
sync backup
system.
showrcopy showrcopy showrcopy “Checking the Links
between Systems”
(page 61) 10. Check the links
between systems.
Create virtual volumes
the same size as the Create virtual volumes
the same size as the Create virtual volumes. 11. Verify virtual
volumes exist. • “Verifying Virtual
Volumes Are
Created for Remote
Copy” (page 62)
volumes on the
primary systems. volumes on the
primary systems.
• HP 3PAR InForm
OS CLI
Administrator’s
Manual
— — creatercopygroup “Creating Volume
Groups for
Synchronous Long 12. Create volume
groups.
:sync
Distance Remote
Copy” (page 62) :
periodic
— — admitrcopyvv “ 13. Add virtual
volumes to their
volume groups.
:
218 Quick Setup Guide