HP 3PAR Operating System Software - Manual (Page 242)

dismissrcopylink
NAME
dismissrcopylink -- The dismissrcopylink command removes one or more links
(connections) created with the admitrcopylink command to a target system.
SYNTAX
•
Syntax for Remote Copy over IP (RCIP) is as follows:
dismissrcopylink ...
•
For Remote Copy over Fibre Channel (RCFC):
dismissrcopylink ...
AUTHORITY
Super, Edit
Any role granted the rcopylink_dismiss right.
NOTE: You need access to all domains in order to run this command.
OPTIONS
None.
SPECIFIERS
The target name, as specified with the creatercopytarget command.
...
Specifies the node, slot, and port of the Ethernet port on the local system and an IP address of
the peer port on the target system. This specifier can be repeated.
...
Specifies the node, slot, and port of the Fibre Channel adaptor port on the primary system and
a World Wide Name (WWN) of the peer port on the target system. This specifier can be
repeated.
RESTRICTIONS
•
This command requires an HP 3PAR Remote Copy Software license. Contact your local service
provider for further information.
•
This command should only be used to remove sending links.
•
This command cannot be used to remove the last link of a target system with started groups.
EXAMPLES
The following example removes the link from the Ethernet port located at 2:2:2 of System 2:
# dismissrcopylink System2 2:2:2:193.1.2.11
NOTES
•
This command is finished with a list of one or more links to be dismissed.
•
For IP targets, this list is made up of pairs composed of the node containing the Ethernet port
on the primary system and an IP address on the backup system.
•
For Fibre Channel targets, this list is made up of sets with the node, slot, and port of the Fibre
Channel adaptor port on the primary system and a WWN address on the backup system.
242 The Remote Copy Commands