HP 3PAR Operating System Software - Manual (Page 246)

histrcvv
NAME
histrcvv -- The histrcvv command shows a histogram of total Remote Copy service times and
backup system Remote Copy service times in a timed loop.
SYNTAX
histrcvv [options ][|]...
AUTHORITY
Any role in the system.
OPTIONS
-d
Specifies the interval in seconds that statistics are sampled from using an integer from 1 through
2147483. If no count is specified, the command uses a 2-second default interval.
-iter
Specifies that the statistics are to stop after the indicated number of iterations using an integer
from 1 through 2147483647.
-t ...|...
Shows only volumes whose group is copied to the specified target name or pattern of names.
Multiple target names or patterns may be specified using a comma-separated list.
-port ...|...
Show only volumes that are copied over the specified port, expressed as , or pattern
of ports. Multiple ports or patterns may be specified using a comma-separated list.
-g ...|...
Shows only volumes whose volume group matches the specified group name or pattern of
names. Multiple group names or patterns may be specified using a comma-separated list.
-sync
Show only volumes that are being copied in synchronous mode.
-periodic
Show only volumes that are being copied in asynchronous periodic mode.
-primary
Show only virtual volumes in the primary role.
-secondary
Show only virtual volumes in the secondary role.
-targetsum
Displays the sums for all volumes of a target.
-portsum
Displays the sums for all volumes on a port.
-groupsum
Displays the sums for all volumes of a volume group.
-vvsum
Displays the sums for all targets and links of a virtual volume.
-domainsum
Displays the sums for all volumes of a domain.
-domain ...|...
Shows only the virtual volumes that are in domains with names that match the specified domain
name(s) or pattern(s).
246 The Remote Copy Commands