beautypg.com

HP 3PAR Operating System Software User Manual

Page 51

background image

1.

Set up a volume group on the primary storage system (for example, System1):

# creatercopygroup :periodic

- Name of the volume group (for example, Group1)

- Name of the target system (for example, System2)

periodic

- Specifies asynchronous periodic mode

NOTE:

N-to-1 configurations support only asynchronous periodic mode volume groups.

For more information, see

“Volume Group Modes” (page 194)

.

The creatercopygroup command:

Creates a primary volume group (Group1) on the primary system (System1).

Creates a name for the corresponding secondary volume group using the convention:

.r

(of the primary system)

Therefore, in this example, the secondary volume group is named Group1.r112.

Creates the corresponding secondary volume group (Group1.r112) on the target system
(in this case, the backup system System2).

Solution

Problem

Ensure links are up on both systems and try the
command again. For more information, see

“Checking

the Links between Systems” (page 70)

.

If the backup system does not respond to a command
after 5 minutes (the timeout limit), an error message
appears:

target system could not be

contacted

2.

(Optional). If you are not using tape to make the first copy of the data on the primary system,
you can set up automatic resynchronization.

CAUTION:

Do not set a resynchronization period at this point if you plan to perform the

initial synchronization and backup using tape. For more information, see

“Using Tape for

Initial Synchronization and Backup” (page 82)

.

To specify a synchronization period for a primary volume group, on the primary system (for
example, System1) enter either:

# setrcopygroup period s|m|h|d

s|m|h|d

- Synchronization period (time between start of

resynchronizations), followed by time unit: s (seconds), m (minutes), h (hours), or d (days)

- Name of the target system (for example, System2)

- Name of the primary volume group (for example, Group1)

or:

# setrcopygroup period s|m|h|d -pat

Creating Remote Copy Volume Groups

51

This manual is related to the following products: