HP 3PAR Operating System Software - Manual (Page 256)

setrcopytarget
NAME
setrcopytarget -- The setrcopytarget command sets the name, policies, or throughput
definition for the target’s links.
SYNTAX
The syntax for the setrcopytarget command can be one of the following:
•
setrcopytarget pol
•
setrcopytarget name
•
setrcopytarget tput
•
setrcopytarget tunelinks
•
setrcopytarget enable|disable
AUTHORITY
Super, Edit
Any role granted the rcopytarget_set right.
NOTE: You need access to all domains in order to run this command.
SUBCOMMANDS
pol
Sets the policy option for the specified target.
name
Changes the name of the indicated target.
tput
Sets the maximum throughput value for each of the target’s links using the
specifier.
tunelinks
Adjust performance values for the target's links using the and
specifiers.
enable|disable
Enables or disables the target.
OPTIONS
None.
SPECIFIERS
Specifies the target name for the target definition previously created with the
creatercopytarget
command.
This specifier can only be used with the pol subcommand. The policy can be one of the
following:
mirror_config|no_mirror_config - Specifies that all configuration commands
(creatercopygroup, removercopygroup, admitrcopyvv, dismissrcopyvv,
setrcopygroup pol/period
, startrcopygroup, and stoprcopygroup) involving
the specified target are duplicated (mirror_config) or not duplicated (no_mirror_config).
If not specified, all configuration commands are duplicated.
256 The Remote Copy Commands