HP 3PAR Operating System Software - Manual (Page 252)

setrcopygroup
NAME
setrcopygroup -- The setrcopygroup command does the following:
SYNTAX
The syntax for the setrcopygroup command can be one of the following:
•
setrcopygroup pol [options] |...
•
setrcopygroup period
|...
•
setrcopygroup mode
|...
•
setrcopygroup [options]
|...
AUTHORITY
Super, Edit
Any role granted the rcopygroup_set right.
SUBCOMMANDS
pol
Sets the policy of the Remote Copy volume group for dealing with I/O failure and error handling.
period
Specifies that groups in asynchronous periodic mode should be periodically synchronized in
accordance with the specified with the specifier.
mode
Specifies the mode to which the volume group will be set.
OPTIONS
-t
Specifies that the setrcopygroup command be applied to all relevant
groups of the indicated target. If no group names are specified, then all groups in that target
that are in the correct state for the specified subcommand will have it applied to them. For
groups with multiple targets, this option must be specified for the recover, restore,
reverse
, and pol subcommands.
-f
Does not ask for confirmation for disaster recovery commands if the or
specifier is used. If -pat is used, confirmation is requested
even if -f is used.
-nostart
Specifies that groups are not started after the role reversal is completed through the recover
and restore specifiers.
-nosync
Specifies that groups are not synced after the role reversal is completed through the recover
and restore specifiers.
-discard
Specifies that if a group has multiple targets that group does not check with its other targets to
see if newer data should be pushed from them. This option is only valid if failover is used
as the specifier.
252 The Remote Copy Commands