HP 3PAR Operating System Software - Manual (Page 214)

Quick Setup: RCIP Transport Layer
Table 2 Quick Setup Steps for RCIP
Backup System Primary System Reference Step
controlport rcip addr
[-f]
controlport rcip
addr [-f]
“Setting Up the Remote
Copy Interface for RCIP”
(page 33) 1. On all RCIP ports, set up
the interface.
showport -rc showport -rc “ 2. Verify IP addresses and
netmask.
controlport rcip gw
[-f]
controlport rcip gw
[-f]
“Setting the Gateway”
(page 34) 3. On all RCIP ports, set the
gateways.
showport -rcip showport -rcip “ 4. Verify gateway IPs.
controlport rcip ping controlport rcip
ping
“Verifying the Servers Are
Connected” (page 35) 5. Verify connectivity.
a. checkrclink
startserver
“Checking Link Throughput
and Latency” (page 36) 6. On all nodes and
systems, check the links.
b. checkrclink
startclient
c. checkrclink
stopserver
controlport rcip mtu
9000
controlport rcip mtu
9000
“Increasing MTU (Optional)”
(page 37) 4. (If possible) On each
port, increase MTU.
controlport rcip ping
-s 8972 -pf
controlport rcip
ping -s 8972 -pf
“ 5. (If MTU increased) On
each port, verify MTU
support.
214 Quick Setup Guide