Introduction, What's new – HP Virtual Connect FlexFabric 10Gb24-port Module for c-Class BladeSystem User Manual
Page 6
Introduction 6
Introduction
What's new
The command line interface user guide contains the following changes for VC 4.10:
•
VC 4.10 no longer supports the HP 4Gb VC-FC Module.
•
Modified the following commands to include the HideUnusedFlexNICs property:
o
add profile
o
set profile
•
The "uncertified" port status is now the "Non-HP" port status.
•
VC 4.10 and VCSU 1.9.0 or later selectively enable the FTP service only when needed during VC
firmware upgrades.
•
Added the auto-deployment (on page
) managed element.
•
The following commands now have IPv6 support:
o
configbackup
o
domain
o
enclosure
o
ldap
o
ldap-certificate
o
log-target
o
profile
o
radius
o
snmp-access
o
snmp-trap
o
ssh
o
ssl-certificate
o
ssl-csr
o
supportinfo
o
tacacs
For more information on VC IPv6 support, see the HP Virtual Connect for c-Class BladeSystem User
Guide on the Installing tab of the HP BladeSystem Technical Resources website
- Virtual Connect Flex-10.10D Module for c-Class BladeSystem Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem Virtual Connect 8Gb 20-port Fibre Channel Module for c-Class BladeSystem Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem