HP Virtual Connect FlexFabric 10Gb24-port Module for c-Class BladeSystem User Manual
Page 30

Command line 30
Item
Description
McastFilter (optional)
The name of an existing Multicast Filter to associate with the connection if
the Multicast Filter name has not been specified. If the name is not
specified, or is set to "None", then the Multicast Filter is left unassigned
and can be assigned later.
McastFilterSet (optional) The name of an existing Multicast Filter Set to associate with the
connection if the Multicast Filterset name has not been specified. If the
name is not specified, or is set to "None", then the Multicast Filter Set is left
unassigned and can be assigned later.
AddressType (optional)
The source of MAC address assignments to be used during the creation of
the new connection. If not specified, the default is the domain default. If
"User-Defined" is specified, both an Ethernet MAC Address and iSCSI
MAC Address must also be specified. Valid values include
"Factory-Default" and "User-Defined".
IMPORTANT: "User-Defined" addresses within the domain address pool
range are permanently depleted from the pool and can only be re-used as
"User-Defined". Deleting the profile does not return the address to the
pool. Deleting the domain is the only way to return "User-Defined"
addresses to the pool.
EthernetMAC (required if
AddressType is
User-Defined)
The user-defined Ethernet MAC address to use for the connection. This
property is required if the AddressType specified is "User-Defined".
iScsiMAC (required if
AddressType is
User-Defined)
The user-defined iSCSI MAC address to use for the connection. This
property is required if the AddressType specified is "User-Defined".
SpeedType (optional)
The requested operational speed for the server port. Valid values include
"Auto", "Preferred", "Custom", and "Disabled". The default value is
"Preferred".
If the speed type is "Auto", the maximum port speed is determined by the
maximum configured speed for the network.
If the speed type is "Preferred", the speed of the network is the same as the
preferred speed of the network to which the connection is associated. If no
preferred speed is configured for a network, it defaults to "Auto".
If the speed type is "Custom", you can configure a speed from 100Mb to
MAX configured speed for the network in 100Mb increments.
If the speed type is "Disabled", bandwidth is not allocated and the server
port status is "Administratively Disabled".
Speed (required if the
SpeedType is Custom)
The user-defined speed for the server port. Valid values include 100Mb to
MAX configured speed for the network in 100Mb increments.
Examples
->add enet-connection MyNewProfile
Network=SomeNetwork
Adds a new Ethernet network connection to a profile
->add enet-connection MyNewProfile
Network=SomeNetwork2 PXE=enabled
Adds a new Ethernet network connection and enables PXE
->add enet-connection MyNewProfile
Adds a new Ethernet network connection and leaves the network
unassigned
->add enet-connection MyNewProfile
AddressType=Factory-Default
Adds a new Ethernet network connection and uses factory default
addresses
->add enet-connection MyNewProfile
AddressType=User-Defined
- Virtual Connect Flex-10.10D Module for c-Class BladeSystem Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem Virtual Connect 8Gb 20-port Fibre Channel Module for c-Class BladeSystem Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem