HP Virtual Connect FlexFabric 10Gb24-port Module for c-Class BladeSystem - Manual (Page 48)

Command line 48
Item Description
->show interconnect
Displays a summary of all interconnect modules
->show interconnect *
Displays detailed information for all interconnect modules
->show interconnect *:5
Displays detailed information for all enclosures with interconnect modules in
interconnect bay number 5
->show interconnect enc0:*
Displays interconnect modules in all bays of a specific enclosure
->show interconnect enc0:3
Displays detailed information on a specific interconnect module in interconnect
bay 3 of the primary enclosure
iscsi-boot-param
Manage iSCSI boot parameters within a domain.
NOTE: The iscsi-boot-param command does not currently support IPv6 addresses.
Supported actions: help, remove, set, show
Item Description
remove
iscsi-boot-param
Remove all iSCSI boot parameters configured on the specified iSCSI
connection.
Syntax
remove iscsi-boot-param
Parameter
ConnectionID
(required)
The ID of an existing iSCSI connection. The ID format is . To
retrieve the port number of the iSCSI connection, use the show profile
command.
Example
->remove iscsi-boot-param MyProfile1:1
Removes boot parameters configured on connection 1 of MyProfile1
Item Description
set iscsi-boot-param Configure the basic iSCSI boot parameters on the specified iSCSI connection.
Syntax
set iscsi-boot-param [-maskSecret]
[-maskMutualSecret]
[BootOrder=]
[LUN=] [InitiatorName=
name>] [InitiatorIP=] [Mask=]
[Gateway=] [VlanID=]
[TargetName=] [TargetIP=]
[TargetPort=] [TargetIP2=
Target IP>] [TargetPort2=]
[Authentication=] [Username=]
[Secret=] [MutualUsername=]
[MutualSecret=]
[iSCSIBootParamDHCP=]
[NetworkParamDHCP=]
[DHCPVendorID=]