HP Virtual Connect FlexFabric 10Gb24-port Module for c-Class BladeSystem - Manual (Page 104)

Command line 104
Item Description
->remove snmp-access Network=192.168.0.0
->remove snmp-access Network=2001::1
Removes a range(s) of IP addresses
->remove snmp-access *
Removes all configured ranges of IP addresses
Item Description
show snmp-access Display the ranges of IP addresses that are already configured to access VC
Ethernet modules using the SNMP interface.
Syntax
show snmp-access
Example
->show snmp-access
Displays all configured ranges of IP addresses
snmp-trap
Manage SNMP trap information.
Supported actions: add, help, remove, set, show, test
Item Description
add snmp-trap Adds a new SNMP trap destination.
You can configure up to five VC-Enet and five VC-FC SNMP trap destinations.
Avoid using duplicate trap destinations. Setting duplicate trap destinations can
result in duplicate traps being sent to the same destination, or only one of the trap
destinations being configured.
Syntax
add snmp-trap Address=
[Community=
string>][Format=][Severity=
severity|All|None>][DomainCategories=
category|All|None>][EnetCategories=
category|All|None>][FcCategories=
category|All|None>]
Parameter
Name (required) A unique name for the new trap being added
Properties
Address (required) IP address or DNS name for the trap destination
Community (optional) The SNMP community name string for the specified trap. If not specified, the default
value is "public". For VC-Enet modules, the maximum string length is 39. For VC-FC
modules, the maximum string length is 24.
Format Format of the new trap. Values are "SNMPv1" and "SNMPv2". If not specified, the
default is "SNMPv1".
Severities Trap severities to send to the destination. Values are "Normal", "Unknown", "Info",
"Warning", "Minor", "Major", "Critical", "All", and "None". Multiple severities
can be specified, separated by commas. The default severity is "None".
DomainCategories The VC domain trap categories to send to the destination. Values are "Legacy",
"DomainStatus", "NetworkStatus", "FabricStatus", "ProfileStatus", "ServerStatus",
"EnetStatus", FcStatus", "All", and "None". Multiple categories can be specified,
separated by commas.
EnetCategories The VC Ethernet trap categories to send to the destination. Values are "PortStatus",
"PortThreshold", "Other", "All", and "None". Multiple categories can be specified,