HP Prime Graphing Calculator - Manual (Page 513)

Programming 509
The buttons and keys you can use to edit your
program are listed in “Program Editor: buttons and
keys” on page 502.
Copy a
program or
part of a
program
You can use the global Copy and Paste commands to
copy part or all of a program. The following steps illustrate
the process:
1. Open the Program Catalog.
Sx
2. Tap the program that has the code you want to copy.
3. Press
SV (Copy).
The menu buttons change to give you options for
copying:
: Marks where the copying or cutting is to begin.
: Marks where the copying or cutting is to
end.
: Select the entire program.
: Cut the selection.
: Copy the selection.
4. Select what you want to copy or cut (using the options
listed immediately above).
5. Tap or .
6. Return to the Program Catalog and open the target
program.
7. Move the cursor to where you want to insert the
copied or cut code.
8. Press SZ (Paste). The clipboard opens. What
you most recently copied or cut will be first in the list
and highlighted already, so just tap
. The code
will be pasted into the program, beginning at the
cursor location.