HP Prime Graphing Calculator - Manual (Page 101)

An introduction to HP apps 97
configuration options are spread across two pages. Tap
to move from the first to the second page, and
to return to the first page.
T i p When you go to Plot view to see the graph of a definition
selected in Symbolic view, there may be no graph shown. The
likely cause of this is that the spread of plotted values is outside
the range settings in Plot Setup view. A quick way to bring the
graph into view is to press V and select Autoscale. This
also changes the range settings in Plot Setup view.
Page 1
Setup field Purpose
TRNG
[Parametric
only]
Sets the range of T-values to be plotted.
Note that here are two fields: one for the
minimum and one for the maximum value.
TSTEP
[Parametric only]
Sets the increment between consecutive T-
values.

RNG
[Polar only]
Sets the range of angle values to be
plotted. Note that here are two fields: one
for the minimum and one for the maximum
value.

STEP
[Polar only]
Sets the increment between consecutive
angle values.
SEQPLOT
[Sequence
only]
Sets the type of plot: Stairstep or Cobweb.
NRNG
[Sequence
only]
Sets the range of N-values to be plotted.
Note that here are two fields: one for the
minimum and one for the maximum value.
HWIDTH
[Stats 1 Var
only]
Sets the width of the bars in a histogram.
HRNG
[Stats 1 Var
only]
Sets the range of values to be included in a
histogram. Note that here are two fields:
one for the minimum and one for the
maximum value.