Start-up, 4 remote communication with pactware, 2 functions of keypad buttons – KROHNE OPTIWAVE 5200 C_F EN User Manual

Page 59

START-UP

OPTIWAVE 5200 C/F

www.krohne.com

07/2013 - 4001904902 - HB OPTIWAVE 5200 R02 en

5.3.2 Functions of keypad buttons

For data on keypad functions, refer to

Normal mode

on page 61.

5.4 Remote communication with PACTware™

PACTware™ displays measurement information clearly on a computer (PC) and lets you
configure the device from a remote location. It is an Open Source, open configuration software
for all field devices. It uses Field Device Tool (FDT) technology. FDT is a communication standard
for sending information between the system and the field device. Field devices are easily
integrated. Installation is supported by a user-friendly Wizard.

Figure 5-2: Local display screen layout in configuration mode

1 Function name
2 Configuration mode symbol
3 Menu number

Keypad button

Function

[Right]

Normal mode:

Normal mode: Enter Information menu (Enter Configuration mode)

Configuration mode:

Configuration mode: Move cursor to the right

[Return / Escape]

Normal mode:

Normal mode: Change units (m, cm, mm, in, ft)

Configuration mode:

Configuration mode: Exit

[Down]

Normal mode:

Normal mode: Change measurement type (distance, level , output (%),

output (mA), conversion, ullage conversion, reflection)

Configuration mode:

Configuration mode: Decrease value or change parameter

[Up]

Normal mode:

Normal mode: Change measurement type (distance, level , output (%),

output (mA), conversion, ullage conversion, reflection)

Configuration mode:

Configuration mode: Increase value or change parameter

1 If you have made a strapping table in menu item 2.8.1 INPUT TABLE for volume or mass measurement, "Conversion"

and "Ullage Conv." will be shown in the list of measurement types