GW Instek GDS-3000 Series User Manual - Manual (Page 59)

MEASUREMENT
59
Before After
3. To undo Autoset, press Undo
Autoset from the bottom menu.
To remove the Undo Autoset
softkey, press any other key.
Change modes 1. Choose between Fit Screen Mode
and AC Priority Mode from the
bottom menu.
2. Press the Autoset key again to use
Autoset in the new mode.
Autoset
Fit Screen Mode AC Priority
Limitation Autoset does not work in the following situations.
 Input signal frequency is less than 20Hz
 Input signal amplitude is less than 30mV