Edwards Signaling FSC Series - Manual (Page 65)

Chapter 4: Dialer programming
FSC Series Technical Reference Manual 57
Option Description Values
Wlk Tst CODE Determines the 4/2 code that the dialer
transmits when the control panel is placed
in walk test mode 0 to 9, and A to F
Default: AF
Drill CODE Determines the 4/2 code that the dialer
transmits when notification appliance
circuits are manually activated 0 to 9, and A to F
Default: AD
Signal Sil CODE Determines the 4/2 code that the dialer
transmits when notification appliance
circuits are automatically or manually
silenced 0 to 9, and A to F
Default: AC
Panel Sil CODE Determines the 4/2 code that the dialer
transmits when the control panel is
silenced 0 to 9, and A to F
Default: CA
Line 1 Trb CODE Determines the 4/2 code that the dialer
transmits when the dialer detects a line cut
or ground fault on LINE 1 0 to 9, and A to F
Default: 68
Line 2 Trb CODE Determines the 4/2 code that the dialer
transmits when the dialer detects a line cut
or ground fault on LINE 2 0 to 9, and A to F
Default: 6E
Program CODE Determines the 4/2 code that the dialer
transmits when the control panel is placed
in program mode 0 to 9, and A to F
Default: C1
Delivery Trb CDE Determines the 4/2 code that the dialer
transmits when the dialer transmits a
signal to an account and the account
doesn’t answer 0 to 9, and A to F
Default: 67
Disable CODE Determines the 4/2 code that the dialer
transmits when the dialer is disabled 0 to 9, and A to F
Default: AE
CS Test CODE Determines the 4/2 code that the dialer
transmits as the test signal when the
control panel is in the normal state 0 to 9, and A to F
Default: DF
Reset CODE Determines the 4/2 code that the dialer
transmits when the control panel is reset 0 to 9, and A to F
Default: AB
Setting IDC 4/2 event activation code options
Table 22 lists the set of IDC 4/2 event activation code options and their default
values.
Review Table 22 and make changes as required. If you don’t need to make any
changes, go to “Setting NAC 4/2 event activation code options“ on page 58.