Edwards Signaling FSC Series - Manual (Page 27)

Chapter 2: Installation
FSC Series Technical Reference Manual 19
Installing the cabinet
Cabinets can be surface mounted or semiflush mounted. Framing and mounting
dimensions are provided below.
To surface mount the cabinet:
1. Position the cabinet on the finished wall surface.
2. Fasten the cabinet to the wall surface where indicated.
To semiflush mount the cabinet:
1. Frame the interior wall as required to support the full weight of the cabinet
and standby batteries.
2. Install the (optional) semiflush trim ring on the cabinet.
3. Fasten the cabinet to the framing studs where indicated.
Figure 5: Panel dimensions and mounting holes
Table 8: Panel dimensions
Model D1 [1] D2 D3 D4 D5 [1]
Three- and
five- zone 19.5 in
(49.5 cm) 3.75 in
(9.5 cm) 9.13 in
(23.2 cm) 10.5 in
(26.67 cm) 14.23 in
(36.14 cm)
Ten-zone 30.0 in
(76.2 cm)
3.75 in
(9.5 cm) 7.75 in
(19.7 cm) 21.27 in
(54.0 cm) 16.25 in
(41.27 cm)
[1] Add 1-1/2 in (3.81 cm) to D1 and D5 dimensions if a trim ring kit is installed.
D1
D2 D3
D4
D5
Surface mounting holes
Semi-flush moun
ting h
ole
s