Edwards Signaling FSC Series - Manual (Page 43)

Chapter 3: Panel programming
FSC Series Technical Reference Manual 35
Step Option Values
LCD first line ALARM TROUBLE SUP POWER DISABLE LCD second line WATERFLO
W
ANN TROUBL
E
BATT TROUBLE GND FAULT SERVICE DETECTOR
110 seconds     
115 seconds     
120 seconds     
125 seconds     
130 seconds     
135 seconds     
140 seconds     
145 seconds     
150 seconds     
8 Disable Lockout      None (default)     
All     
IDC/NAC     
Remote Disconnect     
9 Find Peripherals [4]      XX now on buss     
Find devices     
10 RRM Multi Mode [5]      Common Alarm (default)     
Matrix     
1.  = OFF,  = ON.
[2] Available only when an F-DACT(F) is installed.
[3] Available only when an F-DACT(F) is installed and the panel’s Enable Passcode option is set for Yes.
[4] For result display options, see Table 10 on page 30.
[5] Available only when an FSRRM24 configured for programmable operation (jumper installed on JP2) is
detected on the peripheral bus.