Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) - Manual (Page 59)

Brocade Virtual ADX Switch and Router Guide 45
53-1003246-01
Displaying VLAN information
3
Syntax: show vlans [vlan-id | ethernet portnum]
The vlan-id parameter specifies a VLAN for which you want to display the configuration information.
The ethernet portnum parameter specifies a port. If you use this parameter, the command lists all
the VLAN memberships for the port.
Displaying VLAN information for specific ports
Use one of the following methods to display VLAN information for specific ports.
To display VLAN information for all the VLANs of which port 7/1 is a member, enter the following
command.
Virtual ADX(config)# show vlans
Total PORT-VLAN entries: 2
Maximum PORT-VLAN entries: 8
legend: [S=Slot]
PORT-VLAN 1, Name DEFAULT-VLAN, Priority level0, Spanning tree Off
Untagged Ports: (S2) 1 2
Untagged Ports: (S2) 3
Untagged Ports: (S4) 1 2
Untagged Ports: (S4) 3
Tagged Ports: None
PORT-VLAN 10, Name IP_VLAN, Priority level0, Spanning tree Off
Untagged Ports: (S1) 1 2 3
Tagged Ports: None
IP-subnet VLAN 10.1.1.0 255.255.255.0, Dynamic port enabled
Name: Mktg-LAN
Static ports: None
Exclude ports: None
Dynamic ports: (S1) 1 2 3
PORT-VLAN 20, Name IPX_VLAN, Priority level0, Spanning tree Off
Untagged Ports: (S2) 1 2 3
Tagged Ports: None
IPX-network VLAN 0000ABCD, frame type ethernet_ii, Dynamic port enabled
Name: Eng-LAN
Static ports: None
Exclude ports: None
Dynamic ports: (S2) 1 2 3