Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) - Manual (Page 191)

Brocade Virtual ADX Switch and Router Guide 177
53-1003246-01
Enabling OSPFv3
7
Syntax: show ipsec statistics
Displaying IPsec configuration for an area
The show ipv6 ospf area [area-id] command includes information about IPsec for one area or all
areas. In the example that follows, the IPsec information is in bold. IPsec is enabled in the first area
(area 0) in this example but not in area 3. Note that in area 3, the IPsec key was specified as not
encrypted.
Syntax: show ipv6 ospf area [area-id]
The area-id parameter restricts the display to the specified OSPF area. You can specify the area-id
parameter in the following formats:
• An IPv4 address, for example, 192.168.1.1
• A numerical value in the range 0 through2,147,483,647
Virtual ADX#show ipsec statistics
IPSecurity Statistics
secEspCurrentInboundSAs 1 ipsecEspTotalInboundSAs: 2
secEspCurrentOutboundSA 1 ipsecEspTotalOutboundSAs: 2
IPSecurity Packet Statistics
secEspTotalInPkts: 19 ipsecEspTotalInPktsDrop: 0
secEspTotalOutPkts: 83
IPSecurity Error Statistics
secAuthenticationErrors 0
secReplayErrors: 0 ipsecPolicyErrors: 13
secOtherReceiveErrors: 0 ipsecSendErrors: 0
secAuthenticationErrors 0
secReplayErrors: 0 ipsecPolicyErrors: 13
secOtherReceiveErrors: 0 ipsecSendErrors: 0
secUnknownSpiErrors: 0
Virtual ADX(config-ospf6-router)#show ipv6 ospf area
Authentication: Configured
KeyRolloverTime(sec): Configured: 25 Current: 20
KeyRolloverState: Active,Phase1
Current: None
New: SPI:400, ESP, SHA1
Key:$Z|83OmYW{QZ|83OmYW{QZ|83OmYW{QZ|83OmYW{Q
Interface attached to this area: eth 1
Number of Area scoped LSAs is 6
Sum of Area LSAs Checksum is 0004f7de
Statistics of Area 0:
SPF algorithm executed 6 times
SPF last updated: 482 sec ago
Current SPF node count: 1
Router: 1 Network: 0
Maximum of Hop count to nodes: 0
Area 3:
Authentication: Not Configured
Interface attached to this area:
Number of Area scoped LSAs is 3