Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) - Manual (Page 58)

44 Brocade Virtual ADX Switch and Router Guide
53-1003246-01
Displaying VLAN information
3
The num parameter indicates the maximum number of VLANs.
Increasing the number of virtual routing interfaces you can configure
By default, the number of virtual interfaces (a.k.a. VE interfaces) supported in layer 3 router code is
1024. Increasing the size of the virtual routing interface table, which determines how many virtual
routing interfaces you can configure, allows you to raise this limit up to 4095.
To increase the maximum number of virtual routing interfaces you can configure, enter commands
such as the following at the global CONFIG level of the CLI.
Virtual ADX(config)# system-max virtual-interface 256
Virtual ADX(config)# write memory
Virtual ADX(config)# end
Virtual ADX# reload
Syntax: system-max virtual-interface num
The num parameter indicates the maximum number of virtual routing interfaces. Acceptable
values are up to 4095.
Displaying VLAN information
After you configure the VLANs, you can verify the configuration using the following methods.
NOTE
If a VLAN name begins with “GVRP_VLAN_“, the VLAN was created by the GARP VLAN Registration
Protocol (GVRP). If a VLAN name begins with “STATIC_VLAN_“, the VLAN was created by GVRP and
then was converted into a statically configured VLAN.
Displaying system-wide VLAN information
Use one of the following methods to display VLAN information for all the VLANs configured on the
device.
Enter the following command at any CLI level. This example shows the display for the IP subnet and
IPX network VLANs configured in the examples in
“Configuring an IP subnet VLAN with dynamic
ports” on page 39.