Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) - Manual (Page 183)

Brocade Virtual ADX Switch and Router Guide 169
53-1003246-01
Enabling OSPFv3
7
• Retransmit-interval: The time between retransmissions of LSAs to adjacent routers for an
interface. The command syntax is ipv6 ospf retransmit-interval seconds. The value can be from
0 through3600 seconds. The default is 5 seconds.
• Transmit-delay: The time it takes to transmit Link State Update packets on this interface. The
command syntax is ipv6 ospf transmit-delay seconds. The value can be from 0 through 3600
seconds. The default is 1 second.
Disabling or re-enabling event logging
OSPFv3 does not currently support the generation of SNMP traps. Instead, you can disable or
re-enable the logging of OSPFv3-related events such as neighbor state changes and database
overflow conditions. By default, the Brocade device logs these events.
To disable the logging of events, enter the following command:
Virtual ADX(config-ospf6-router)# no log-status-change
Syntax: [no] log-status-change
To re-enable the logging of events, enter the following command:
Virtual ADX(config-ospf6-router)# log-status-change