Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) - Manual (Page 202)

188 Brocade Virtual ADX Switch and Router Guide
53-1003246-01
Displaying OSPFv3 information
7
For example, to display detailed information about Ethernet interface 2, enter the following
command at any level of the CLI:
Status The status of the link. Possible status include the following:
•
Up
•
Down
State The state of the interface. Possible states includes the following:
•
DR – The interface is functioning as the Designated Router for OSPFv3.
•
BDR – The interface is functioning as the Backup Designated Router for
OSPFv3.
•
Loopback – The interface is functioning as a loopback interface.
•
P2P – The interface is functioning as a point-to-point interface.
•
Passive – The interface is up but it does not take part in forming an
adjacency.
•
Waiting – The interface is trying to determine the identity of the BDR for
the network.
•
None – The interface does not take part in the OSPF interface state
machine.
•
Down – The interface is unusable. No protocol traffic can be sent or
received on such a interface.
•
DR other – The interface is a broadcast or NBMA network on which
another router is selected to be the DR.
Area The OSPF area to which the interface belongs.
TABLE 26 Summary of OSPFv3 interface information (Continued)
This Field... Displays...
Virtual ADX# show ipv6 ospf interface ethernet 3
ethe 3 is up, type BROADCAST
IPv6 Address:
2001:db8:2002:c0a8:46a::1/64
2001:db8:2000:4::106/64
Instance ID 0, Router ID 223.223.223.223
Area ID 0, Cost 1
State DR, Transmit Delay 1 sec, Priority 1
Timer intervals :
Hello 10, Dead 40, Retransmit 5
DR:223.223.223.223 BDR:1.1.1.1 Number of I/F scoped LSAs is 2
DRElection: 5 times, DelayedLSAck: 523 times
Neighbor Count = 1, Adjacent Neighbor Count= 1
Neighbor:
1.1.1.1 (BDR)
Statistics of interface ethe 3/2:
Type tx rx tx-byte rx-byte
Unknown 0 0 0 0
Hello 3149 3138 1259284 1255352
DbDesc 7 6 416 288
LSReq 2 2 80 152
LSUpdate 1508 530 109508 39036
LSAck 526 1398 19036 54568