Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) - Manual (Page 221)

Brocade Virtual ADX Switch and Router Guide 207
53-1003246-01
Configuring BGP4
8
FIGURE 29 BGP4 configuration levels
Table 35 shows the commands that are available at the various BGP4 configuration levels.
TABLE 35 IPv4 BGP4 commands for different configuration levels
Command Global
(iPv4 and
IPv6) IPv4 address
family unicast See
address-family x x “Entering and exiting the address family configuration level”
on page 211
aggregate-address x “Aggregating routes advertised to BGP4 neighbors” on
page 211
always-compare-med x “Configuring the device to always compare Multi-Exit
Discriminators”
on page 212
as-path-ignore x “Disabling or re-enabling comparison of the AS-Path length”
on page 213
bgp-redistribute-internal x “Redistributing IBGP routes” on page 213
compare-med-empty-as
path x “Configuring the device to always compare Multi-Exit
Discriminators”
on page 212
compare-routerid x “Enabling or disabling comparison of device IDs” on
page 213
dampening x “Configuring route flap dampening” on page 220
default-information-origi
nate x “Originating the default route” on page 221
default-local-preference x “Changing the default local preference” on page 221
default-metric x “Changing the default metric used for redistribution” on
page 222
distance x “Changing administrative distances” on page 222
enforce-first-as x “Requiring the first AS to be the neighbor AS” on page 223
exit-address-family x x “Entering and exiting the address family configuration level”
on page 211
fast-external-fallover x “Enabling fast external fallover” on page 224
local-as x “Setting the local AS number” on page 225
maximum-paths x “Configuring BGP4 multipath load sharing” on page 225
med-missing-as-worst x “Configuring paths without MEDs as the least favorable” on
page 228