Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) - Manual (Page 208)

194 Brocade Virtual ADX Switch and Router Guide
53-1003246-01
Displaying OSPFv3 information
7
To display all IPv6 routes that the device has redistributed into OSPFv3, enter the following
command at any level of the CLI:
Syntax: show ipv6 ospf redistribute route [ipv6-prefix]
The ipv6-prefix parameter specifies an IPv6 network prefix. (You do not need to specify the length
of the prefix.)
For example, to display redistribution information for the prefix 2001:db8:2002::, enter the
following command at any level of the CLI:
These displays show the following information:
Displaying OSPFv3 route information
You can display the entire OSPFv3 route table for the Brocade device or only the route entries for a
specified destination.
TABLE 31 OSPFv3 redistribution information
This Field... Displays...
ID An ID for the redistributed route.
Prefix The IPv6 routes redistributed into OSPFv3.
Protocol The protocol from which the route is redistributed into OSPFv3. Redistributed
protocols can be the following:
•
Static – IPv6 static route table.
•
Connected – A directly connected network.
Metric Type The metric type used for routes redistributed into OSPFv3. The metric type can
be the following:
•
Type-1 – Specifies a small metric (2 bytes).
•
Type-2 – Specifies a big metric (3 bytes).
Metric The value of the default redistribution metric, which is the OSPF cost of
redistributing the route into OSPFv3.
Virtual ADX# show ipv6 ospf redistribute route
Id Prefix Protocol Metric Type Metric
snIpAsPathAccessListStringRegExpression
1 2001:db8:2002::/16 Static Type-2 1
2 2001:db8:2002:1234::/32 Static Type-2 1
Virtual ADX#show ipv6 ospf redistribute route 2001:db8:2002::
Id Prefix Protocol Metric Type
Metric
1 2001:db8:2002::/16 Static Type-2