Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) - Manual (Page 43)

Brocade Virtual ADX Switch and Router Guide 29
53-1003246-01
Overview
3
FIGURE 5 Use virtual routing interfaces for routing between IP subnet VLANs
VLAN and virtual routing interface groups
To simplify configuration, you can configure VLAN groups and virtual routing interface groups. When
you create a VLAN group, the VLAN parameters you configure for the group apply to all the VLANs
within the group. Additionally, you can easily associate the same IP subnet interface with all the
VLANs in a group by configuring a virtual routing interface group with the same ID as the VLAN
group.
Dynamic, static, and excluded port membership
When you add ports to an IP subnet VLAN, you can add them dynamically or statically:
• Dynamic ports