Displaying ospf information, Displaying general ospf configuration information – Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) User Manual
Page 151

Brocade Virtual ADX Switch and Router Guide
137
53-1003246-01
Displaying OSPF information
6
Displaying OSPF information
You can use CLI commands and Web management options to display the following OSPF
information:
•
Trap, area, and interface information – refer to
“Displaying general OSPF configuration
•
CPU utilization statistics – refer to
“Displaying CPU utilization statistics”
•
Area information – refer to
“Displaying OSPF area information”
•
Neighbor information – refer to
“Displaying OSPF neighbor information”
•
Interface information – refer to
“Displaying OSPF interface information”
•
“Displaying OSPF route information”
•
External link state information – refer to
“Displaying OSPF external link state information”
•
Link state information – refer to
“Displaying OSPF link state information”
•
Virtual Neighbor information – refer to
“Displaying OSPF virtual neighbor information”
•
Virtual Link information – refer to
“Displaying OSPF virtual link information”
•
ABR and ASBR information – refer to
“Displaying OSPF ABR and ASBR information”
•
Trap state information – refer to
Displaying general OSPF configuration information
To display general OSPF configuration information, enter the following command at any CLI level.