Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) - Manual (Page 157)

Brocade Virtual ADX Switch and Router Guide 143
53-1003246-01
Displaying OSPF information
6
Displaying OSPF interface information
To display OSPF interface information, enter the following command at any CLI level.
Syntax: show ip ospf interface [ip-addr]
The ip-addr parameter displays the OSPF interface information for the specified IP address.
The following table defines the highlighted fields shown in the above example output of the show ip
ospf interface command.
TABLE 16 Output of the show ip ospf interface command
This field Displays
IP Address The IP address of the interface.
OSPF state ptr2ptr (point to point)
Pri The link ID as defined in the router-LSA. This value can be one of the
following:
1 = point-to-point link
3 = point-to-point link with an assigned subnet
Cost The configured output cost for the interface.
Options OSPF Options (Bit7 - Bit0):
•
unused:1
•
opaque:1
•
summary:1
•
dont_propagate:1
•
nssa:1
•
multicast:1
•
externals:1
•
tos:1
Type The area type, which can be one of the following:
•
Broadcast = 0x01
Events OSPF Interface Event:
•
Interface_Up = 0x00
•
Wait_Timer = 0x01
•
Backup_Seen = 0x02
•
Neighbor_Change = 0x03
•
Loop_Indication = 0x04
•
Unloop_Indication = 0x05
•
Interface_Down = 0x06
•
Interface_Passive = 0x07
Virtual ADX# show ip ospf interface 192.168.1.1
Ethernet 1,OSPF enabled
IP Address 192.168.1.1, Area 0
OSPF state ptr2ptr, Pri 1, Cost 1, Options 2, Type pt-2-pt Events 1
Timers(sec): Transit 1, Retrans 5, Hello 10, Dead 40
DR: Router ID 0.0.0.0 Interface Address 0.0.0.0
BDR: Router ID 0.0.0.0 Interface Address 0.0.0.0
Neighbor Count = 0, Adjacent Neighbor Count= 1
Neighbor: 10.2.2.2
Authentication-Key:None
MD5 Authentication: Key None, Key-Id None, Auth-change-wait-time 300