Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) - Manual (Page 195)

Brocade Virtual ADX Switch and Router Guide 181
53-1003246-01
Displaying OSPFv3 information
7
Displaying OSPFv3 information
You can display the information for the following OSPFv3 parameters:
• Areas
• Link state databases
• Interfaces
• Memory usage
• Neighbors
• Redistributed routes
• Routes
• SPF
• Virtual links
• Virtual neighbors
Displaying OSPFv3 area information
To display global OSPFv3 area information for the Brocade device, enter the following command at
any CLI level:
Syntax: show ipv6 ospf area [area id]
You can specify the area-id parameter in the following formats:
• As an IPv4 address, for example, 192.168.1.1.
• As a numerical value from 0 through2,147,483,647.
The area-id parameter restricts the display to the specified OSPF area.
This display shows the following information:
TABLE 23 OSPFv3 area information fields
This Field... Displays...
Area The area number.
Interface attached to this area The router interfaces attached to the area.
Number of Area scoped LSAs Number of LSAs with a scope of the specified area.
SPF algorithm executed The number of times the OSPF Shortest Path First (SPF) algorithm is
executed within the area.
Virtual ADX# show ipv6 ospf area
Area 0:
Interface attached to this area: loopback 2 ethe 3 tunnel 2
Number of Area scoped LSAs is 6
Statistics of Area 0:
SPF algorithm executed 16 times
SPF last updated: 335256 sec ago
Current SPF node count: 3
Router: 2 Network: 1
Maximum of Hop count to nodes: 2
...