Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) - Manual (Page 154)

140 Brocade Virtual ADX Switch and Router Guide
53-1003246-01
Displaying OSPF information
6
Displaying OSPF area information
To display OSPF area information, enter the following command at any CLI level.
Syntax: show ip ospf area [area-id] | [num]
The area-id parameter shows information for the specified area.
The num parameter displays the entry that corresponds to the entry number you enter. The entry
number identifies the entry’s position in the area table.
This display shows the following information.
Displaying OSPF neighbor information
To display OSPF neighbor information, enter the following command at any CLI level.
To display detailed OSPF neighbor information, enter the following command at any CLI level.
TABLE 14 CLI display of OSPF area information
This Field... Displays...
Indx The row number of the entry in the router’s OSPF area table.
Area The area number.
Typet The area type, which can be one of the following:
•
nssa
•
normal
•
stub
Cost The area’s cost.
SPFR The SPFR value.
ABR The ABR number.
ASBR The ABSR number.
LSA The LSA number.
Chksum(Hex) The checksum for the LSA packet. The checksum is based on all the fields in
the packet except the age field. The Layer 3 Switch uses the checksum to verify
that the packet is not corrupted.
Virtual ADX show ip ospf area
Indx Area Type Cost SPFR ABR ASBR LSA Chksum(Hex)
1 0.0.0.0 normal 0 1 0 0 1 0000781f
2 10.147.60.0 normal 0 1 0 0 1 0000fee6
3 10.147.80.0 stub 1 1 0 0 2 000181cd
Virtual ADX show ip ospf neighbor
Port Address Pri State Neigh Address Neigh ID
8 10.76.7.251 1 full 10.76.7.200 10.35.1.220