Brocade Virtual ADX Switch and Router Guide (Supporting ADX v03.1.00) - Manual (Page 122)

108 Brocade Virtual ADX Switch and Router Guide
53-1003246-01
Configuring OSPF
6
• Enable or disable default-information-originate.
• Modify Shortest Path First (SPF) timers
• Define external route summarization
• Define redistribution metric type.
• Define deny redistribution.
• Define permit redistribution.
• Enable redistribution.
• Change the LSA pacing interval.
• Modify OSPF Traps generated.
• Modify database overflow interval.
• Enable and configure graceful restart
Interface parameters:
• Assign interfaces to an area.
• Define the authentication key for the interface.
• Change the authentication-change interval
• Modify the cost for a link.
• Modify the dead interval.
• Modify MD5 authentication key parameters.
• Modify the priority of the interface.
• Modify the retransmit interval for the interface.
• Modify the transit delay of the interface.
NOTE
When using the CLI, you set global level parameters at the OSPF CONFIG Level of the CLI. To reach
that level, enter router ospf at the global CONFIG Level. Interface parameters for OSPF are set at the
interface CONFIG Level using the CLI command, ip ospf.
When using the Web management interface, you set OSPF global parameters using the OSPF
configuration panel. All other parameters are accessed through links accessed from the OSPF
configuration sheet.
Enable OSPF on the router
When you enable OSPF on the router, the protocol is automatically activated. To enable OSPF on
the router, use the following method.
Virtual ADX(config)# router ospf
This command launches you into the OSPF router level where you can assign areas and modify
OSPF global parameters.