Proface GP4600R - 12.1 Standard HMIs with Rear Mounting Options" - Manual (Page 39)

GP4000 Series Hardware Manual
39
*1 Status LED operations are as shown below:
*2 SD Card Access LED operations are as shown below.
*3
Ethernet LED operations are as shown below.
F SD Card Interface
Cover/Replacement Battery
Insertion Cover For information on how to open the cover, and
insert or remove the SD Card, refer to SD Card
Insertion/Removal (see page 150).
For information on how to open the cover and
replace the battery, refer to Replacing the
Primary Battery (see page 168).
G Serial Interface (COM2) GP-4501T/GP-4501TW: RS-422/485 Serial
Interface. Connector: D-Sub 9 pin (plug) x 1.
GP-4503T: RS-485 (isolation) Serial Interface.
Connector: D-Sub 9 pin (socket) x 1.
H Serial Interface (COM1) RS-232C Serial Interface.
Connector: D-Sub 9 pin (plug) x 1.
I USB (Type A) Interface Conforms to USB2.0 (Type A) x 1. Power
supply voltage: 5Vdc+/-5%. Output Current:
500 mA or less. Maximum communication
distance: 5 m (16.4 ft).
Color Indicator Operation Mode
(Drawing) Logic execution mode
(when logic is enabled)
Green ON Offline –
In operation RUN
Flashing In operation STOP
Orange Flashing Software starting up.
Red ON Power is turned ON.
Flashing In operation Major Error
LED fade
(Green) ON The GP unit’s "Backlight Control" is set to Standby Mode
and the screen has gone blank.
- OFF Power is turned OFF.
Color Indicator Description
Green (Active) ON The SD Card is inserted.
OFF The SD Card is not inserted or is not
being accessed.
Color Indicator Description
Green (Active) Flashing Data transmission is occurring.
OFF No data transmission.
Green (Link) ON Data transmission is available in
10BASE-T/100BASE-TX.
OFF No connection or subsequent
transmission failure.
Part Name Description
Link
Active