Proface GP4600R - 12.1 Standard HMIs with Rear Mounting Options" - Manual (Page 182)

182
7.5 Structural Specifications
NOTE:
(1) Protection structure equivalent to IP65F *1 can be expected if you affix the
Overlay (sold separately) on the screen of the GP unit and the surroundings. Pro-
face does not guarantee the protective structure.
Consider the the protective structure in combination with a panel or a resin plate
within your quality assurance range.
Use the Overlay manufactured by Pro-face. Use one of the following models.
z PFXZGPFSR6W1 (for the PFXGP4301TADR)
z PFXZGPFSR7W1 (for the PFXGP4401TADR)
z PFXZGPFSR10W1 (for the PFXGP4501TADR)
z PFXZGPFSR12W1 (for the PFXGP4601TADR)
*1 This is a protective structure for the front face of the Overlay manufactured by Pro-
face and that has been correctly affixed to a panel or to a resin sheet. The
performance of the sheet according to the material properties of the overlay in
combination with a panel or a resin sheet has been confirmed under appropriate test
conditions, but this does not guarantee that the protective structure enables the Pro-
face Overlay to be used in any and all environments. In certain situations, the sheet
can be damaged. This can occur in areas where either vaporized oils are present,
or where low viscosity cutting oils are allowed to adhere to the Overlay for long
periods of time. If the Overlay becomes peeled off, these conditions can lead to the
ingress of oil into the GP unit and separate protection measures are suggested.
PFXGP4301TA
DR PFXGP4401TA
DR PFXGP4501TA
DR PFXGP4601TA
DR
Grounding
Functional grounding:Grounding resistance of 100Ω, 2mm 2 (AWG 14) or
thicker wire, or your country's applicable standard. (Same for FG and SG
terminals)
Cooling Method Natural air circulation
Protection
structure
IP20 (1)(2)
External
dimensions
(not attached
installation
fasteners) W155.6 x
H123.4 x D59.7
mm (W6.13 x
H4.86 x D2.35
in.) W204 x H159.4
x D60.4 mm
(W8.03 x H6.28
x D2.38 in.) W259.7 x
H201.5 x
D57.6mm
(W10.22 x
H7.93 x D2.27
in.) W302 x H228 x
D56.6mm
(W11.89 x
H8.98 x D2.23
in.)
Panel cut
dimensions
(3)(4)(5)
depends on the installation method.
Refer to "Panel Cut Dimensions" (page. 223)
Weight approx. ≤ 1 kg (2.2 lb.)
(including the
installation
fasteners) ≤ 1.4 kg (3.1 lb.)
(including the
installation
fasteners) ≤ 2.3 kg (5.1 lb.)
(including the
installation
fasteners) ≤ 2.8 kg (6.2 lb.)
(including the
installation
fasteners)