Proface GP4600R - 12.1 Standard HMIs with Rear Mounting Options" - Manual (Page 238)

238
10 When installing the GP unit with the flat mount orientation, affix the Overlay to
the front of the GP unit.
In advance, align the four corners of the Overlay outline on the panel as shown
in the figure, and then mark these corners.
Peel off the removable paper layer from the Overlay, align the Overlay with the
four marks, and then affix the Overlay to the panel.
1) Locations to mark (four locations)
2) Overlay outline
e) Display area
Note: Use the Overlay manufactured by Pro-face. Use one of the following
models.
z PFXZGPFSR6W1 (for the PFXGP4301TADR)
z PFXZGPFSR7W1 (for the PFXGP4401TADR)
z PFXZGPFSR10W1 (for the PFXGP4501TADR)
z PFXZGPFSR12W1 (for the PFXGP4601TADR)
NOTICE
BROKEN ENCLOSURE
z Attach the Overlay correctly with the installation.
z Do not reuse the Overlay removed once.
z Do not exert more than 0.8 N•m (7.1 lb-in) of torque when tightening the
installation screws.
z For use on a flat surface of a Type 1 Enclosure
z Attach correctly without a crevice between gaskets and between gasket and the
panel.
z Do not attach installation fastener in a different position from mounting
instruction.
Failure to follow these instructions can result in equipment damage.
Step Procedure Details
); );
)<
)<
H
mm(in.)
(dimensional tolerance:
±0.2mm [0.01 in.])
FX FY
PFXGP4301TADR 84.0 (3.31) 66.0 (2.60)
PFXGP4401TADR 99.7 (3.93) 78.6 (3.09)
PFXGP4501TADR 133.3 (5.25) 105.5 (4.15)
PFXGP4601TADR 158.5 (6.24) 118.7 (4.67)