IEI Integration ICE-DB-T6 - Manual (Page 73)

Type 6 Carrier Board Design Guide
Page 63
"PS_ON" and can be used to control an ATX power supply.
B66 WAKE0# I CMOS PCI Express wake up signal.
B67 WAKE1# I CMOS General purpose wake up signal. May be used to
implement wake-up on PS2 keyboard or mouse activity.
A27 BATLOW# I CMOS Indicates that external battery is low.
B35 THRM# I CMOS Input from off-module temp sensor indicating an over-temp
situation.
A35 THERMTRIP# O CMOS Active low output indicating that the CPU has entered
thermal shutdown.
B102 FAN_TACHOIN I CMOS 0V~5V Fan Tachometer Input
B101 FAN_PWMOUT O CMOS Fan Speed Control PWM Control
B13
B14 SMB_C
SMB_DAT I/O 3.3V
OD
CMOS System Management Bus (SMBus) is used by the COM
Express module for memory configuration and clock
synthesizer configuration. It is also used by the external
PCI Express slots and ExpressCard slots.
B15 SMB_ALERT# I 3.3V
CMOS
The SMBus alert signal used by the SMBus slave to inform
the SMBus master " Optional signal used by the SMBus
slave. that a slave transaction is pending.
B33
B34 I2C_CK
I2C_DAT I/O 3.3V
CMOS General purpose I2C bus for common usage on the carrier
board.
B32 SPKR O CMOS Output for audio enunciator - the "speaker" in PC-AT
systems
A34 BIOS_DISABLE# I CMOS Module BIOS disable input. Pull low to disable module
BIOS. Used to allow off-module BIOS implementations.
B88 BIOS_DIS1# I CMOS Selection straps to determine the BIOS boot device. The
Carrier should only float these or pull them low.
B27 WDT O CMOS Output indicating that a watchdog time-out event has
occurred.
A54
A63
A67
A85 GPI0
GPI1
GPI2
GPI3 I CMOS General purpose input pins.
A93
B54
B57
B63 GPO0
GPO1
GPO2
GPO3 O CMOS General purpose output pins.
A91 SPI_VCC O 3.3V BIOS flash interface
A92 SPI_MISO O CMOS Data in to Module from Carrier SPI
A94 SPI_CLK O CMOS Clock from Module to Carrier SPI
A95 SPI_MOSI O CMOS Data out from Module to Carrier SPI
B97 SPI_CS# O CMOS Chip select for carrier board SPI
A96 PP_TPM I CMOS Trusted Platform Module (TPM). Active high. TPM chip has
an internal pull down. This signal is used to indicate
Physical Presence to the TPM.
A98 RS1_TX O UART
A99 RS1_RX I UART
A101 RS2_TX O UART
A102 RS2_RX I UART
Table 3-21: Miscellaneous Pin Assignment