Teledyne LeCroy Conquest User Manual - Users Manual - Manual (Page 84)

Protocol Analysis
74
3. Highlight the new class name and click the Add button to open the
Request Specification dialog.
4. Enter a request name, request type code and a data default value, and
click OK.
5. Repeat for all requests for the new class.
6. To modify a previously entered request, click the Modify button, enter
the new parameters in the Request Specification dialog, and click OK.
Specifying Data for Transfer
You can define data for transfer at the Transfer layer or at the Transaction
layer.
Specify data in Transfer layer
Click Transfer Data(Hex) to enable the Block transfer field. Either click the
down arrow next to this field and choose a pre-defined data block from the
drop-down list, or highlight the field and type specific data that to use in this
transfer.
Note: The entry format is selectable as described for EndP(Hex)
Figure 51 Choosing Data to Transfer
Note Important: A significant advantage of this method of Data Transfer setup is
that the Exerciser program automatically generates the number of
transactions, based on maximum packet size, required to transfer the
data block. This is especially useful for large data blocks requiring perhaps
hundreds of transactions.
When the Endpoint number and the data to transfer has been specified, click
the blank program entry area to register the choice. Once the choice is
registered, the Bytes Transferred(Dec) field displays the number of data out
Transactions created.
You can add additional transfers.